Skipping CAN extended address (not supported yet) 60ĭuring a previous session i got this as well :įile "/home/ion/02_ddt/ddt4all-master/parameters.py", line 79, in tester_send Skipping CAN extended address (not supported yet) 41 Skipping CAN extended address (not supported yet) D2 Skipping CAN extended address (not supported yet) DA Skipping CAN extended address (not supported yet) 2D Īlso, after second scan errors are looping until i select an ecu Just selecting the radio screens does not report an error. To explain better : it complains about bad response every time i select a screen for the MFD device (and BIC). I get the error when loading the screen as well (radio ecu is fine, no errors) There is a radio device on the same multimedia can, i was able to write to that one.Īnd also, all these devices are properly detected when i scan. Maybe we need not run flow control on multimedia can ? Running on a different car (2014 Megane 3)īad ELM response : WRONG RESPONSE : UnknownĪt a previous attempt i was getting "Wrong response CFC0". Pins remapped as described earlier in the topic ![]() Setup : - Chinese ELM clone running 1.5 (tested with ELM identifier working with commands up to 1.4) (also other changes on normal can bus are possible without errors) I am trying the same thing from ubuntu, no luck. Color changes once you start modifying the options.
0 Comments
Leave a Reply. |